Description
Description
ForzaBOND™ C-130 is a flammable, high-performance, neoprene industrial contact adhesive.
Applications
- Designed for laminating and general bonding to many
substrates - Laminates a wide variety of materials
- Bonds a wide variety of materials
Benefits
- Post formable
- Excellent coverage
- High-temperature resistance
- 80% of final strength achieved upon bonding
- Full strength achieved in 24 hours
- Fast drying
- No ODS (Ozone Depleting Substances)
- No chlorinated solvents
- Sprayable/ Rollable/ Brushable
How to Use
- Be sure all surfaces are clean and free of grease, dirt, dust, etc. Apply to both surfaces to be bonded by brushing, rolling or spraying.
- Adhesive should be applied to each surface,allowed to dry (until non transferable to finger), then bonded under pressure.
- Whenbrushing, multiple coats may be required on porous surfaces.
- When spraying, use of DeVilbiss JGA gun with FX tip and needle or Binks 2001 or 95 gun and 63B tip 2nd needle or similar equipment is satisfactory.
- Adhesive should be applied at a minimum of 2.0 dry grams per square foot.
- Apply pressure with a hand laminate roller or nip roller. If adhesive is left to dry for over 30 minutes, parts should be recoated.
- Normal coverage required with web spray pattern is approximately 80%. Initial bond is strong enough to allow cutting or trimming immediately although ultimate strength is achieved in 1-3 days.
- Store away from heat, flames or other sources of ignition. If spray tip clogs, unscrew the spray tip from the gun and clean with a solvent such as lacquer thinner or acetone.
- Do not use a pin on the spray tip orifice.
Sizing
- 1 Gallon
- 5 Gallon Pail
- 52 Gallon Drum
