skip to content



ForzaBOND™ C331 is a non-flammable high-performance spray contact adhesive. 


  • Bonds veneers, fabrics, upholstery, foam, headliners, cork, fiberglass and many plastics 
  • Also bonds applications where smoothness is required (e.g. glossy or thin laminate, fabrics) 
  • Laminating flexible material in nearly any applications 


  • Non-flammable 
  • Excellent high coverage 
  • Over 220°F (105°C) temperature resistant 
  • 80% of final strength achieved immediately; full strength achieved in 24 hours 
  • Fast drying with long open time 
  • No ODS (Ozone Depleting Substances) 
  • VOC free 
  • Qualifies for LEED®-NC & CI EQ Credit 4.4: laminating adhesives shall contain no urea formaldehyde resins 

How to Use

  • Be sure all surfaces are clean and free of grease, dirt, dust, etc. Apply to both surfaces to be bonded by brushing, rolling or spraying. 
  • Adhesive should be applied to each surface, allowed to dry (until non-transferable to finger), then bonded under pressure. 
  • When brushing, multiple coats may be required on porous surfaces. 
  • When spraying, use of DeVilbiss JGA gun with FX tip and needle or Binks 2001 or 95 gun and 63B tip 2nd needle or similar equipment is satisfactory. 
  • Adhesive should be applied at a minimum of 2.0 dry grams per square foot. Apply pressure with a hand laminate roller or nip roller. 
  • Bonds should be made as soon as practical. 
  • Normal coverage required with a web spray pattern is approximately 80% 
  • Initial bond is strong enough to allow cutting or trimming immediately although ultimate strength is achieved in 1-3 days. 
  • Store away from heat, flames, or other sources of ignition. 
  • If the spray tip clogs, unscrew the spray tip from the gun and clean it with a solvent such as lacquer thinner or acetone. Do not use a pin on the spray tip orifice. 


  • 1 Gallon
  • 5 Gallon Pail
  • 52 Gallon Drum


Request Product Quote

Need Faster Information? Give us a Call!

Scroll to Top